2.5-Inch Hot-Swap Drives Model - Lenovo ThinkSystem SR250 V3 System Configuration Manual

4 Front I/O module
For more information about the front I/O module, see
5 3.5-inch hot-swap drive bays
Install 3.5-inch hot-swap drives to these bays. See "Install a hot-swap drive" in ThinkSystem SR250 V3 User
Guide or ThinkSystem SR250 V3 Hardware Maintenance Guide.
6 Rack release latches
Press on the latch on both sides to disengage the server from the rack and slide it out.

2.5-inch hot-swap drives model

The front view of 2.5-inch hot-swap drives model.
Note: Depending on the configuration, your server might be slightly different from the image.
Figure 4. 2.5-inch hot-swap drives model front view
Note: The last two drive bays (8-9) may not be supported if only the eight-bay backplane is installed.
USB 2.0 connector with Lenovo XClarity Controller
1
management
USB 3.2 Gen 1 (5 Gbps) connector
2
Front I/O module
3
ThinkSystem SR250 V3 System Configuration Guide
18
"Front I/O module" on page
VGA connector (optional)
4
2.5-inch hot-swap drive bays
5
Rack release latches
6
24.