Advertisement
RXITX
RX: For receive operation
TX: For transmit operation
Function
e
command
Input
commands
Read
command
Output
commands
Answer
command
After the TX command is excuted, the receiving mode cannot be resumed by the SEND switch, etc. on the transceiver. (This
condition is reset by turning the power off.) Unless the receiving mode is resumed by the RX command, operation of the SEND
switch on the transceiver cannot be performed.
Special attention should be paid, when this command is excuted at frequencies which do not have actual power, the ON AIR LED
is not lit.
When "?;" is replied to the TX command, the TX command is ignored, however, it is recommended to use the TX command in
combination with the RX command if possible.
Description
30
Advertisement
