Troubleshooting - Electrolux EOF6H46Z User Manual

12.5 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the appliance and wait until it is
cold.
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
CAUTION!
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate or operate the appliance.
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
The lamp is turned off.
The lamp does not work.
The door gasket is damaged.
The display shows 00:00.
If the display shows an error code that is
not in this table, turn the house fuse off
and on to restart the appliance. If the
error code recurs contact an Authorised
Service Centre.
42 ENGLISH
Back lamp
1. Turn the glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
Check if...
The appliance is correctly connected to an electrical
supply.
The automatic switch-off is deactivated.
The fuse is not blown.
Lock is deactivated.
Moist Fan Baking - is activated.
The lamp is burnt out.
Do not use the appliance. Contact an Authorised Serv‐
ice Centre.
There was a power cut. Set the time of day.
13.2 Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is located
on the front frame of the appliance. It is
visible when you open the door. Do not
remove the rating plate from the appliance.