Pioneer CT-1270WR Service Manual page 5

C T - I S T O W R C B K :
4. D I S A S S E M B L Y
4.1 Removal of the Bonnet.
1. Remove the three screws
zyxwvutsrqponmlkjihgfedcbaZYXWVUTSRQPONMLKJIHGFEDCBA
Q
and remove the bonnet.
Bonnet
Fig. 4-1 Removal of the bonnet
4.2 Removal of the Mechanica! U nit
1. Remove the three screws
zyxwvutsrqponmlkjihgfedcbaZYXWVUTSRQPONMLKJIHGFEDCBA
Q and take off the top plate.
Top plate
Fig. 4-2 Removal of the top plate.
2. Remove the switch lever and SW connector spring from DECK
2 (RYM-203).
DECK II DECKI
^.y-A ^.y-A
a
Fig. 4-3 Removal of the SW connector
spring
3. Remove the 5 screws Q and take off the front panel.
0.
Fig. 4-4 Removal of the front panel
4. Pass the counter belt from the counter around a boss in DECK
2. Remove the eight screws Q .
If there is difficulty in removing screws, first take off the
connector and remove the front panel.
Counter belt
plate boss.
O O O O
Fig. 4-5 Removal of the mechanical unit
4.3 Belt Replacement Procedure.
1. First remove the mechanical unit from the main body. (See
4-2 for removal of the mechanical unit).
2. Remove the angular belt (FR belt) from the machanical unit.
3. Remove the single screw Q . Remove the REC SW bracket.
(DECK 2 {RYM-203) only).
EC SW Bracket
Capstan motor
Fig. 4-6 Removal of the REC SW Bracket
7