Connect Ac Power To The Chassis - Cisco CQ211L01-48H8FH Hardware Installation Manual

Installing the Chassis
Connect AC Power to the
Chassis
Cautio
The chassis relies on the protective devices in the building installation to protect against short circuit,
n
overcurrent, and ground faults. Ensure that the protective devices comply with local and national
electrical codes.
Not
We recommend that you occupy both the power supply slots of the fixed port routers with power
e
supplies. In case a power module fails, it is recommended to retain the failed power module in its slot
until it is replaced with a new power module. This recommendation ensures that the system airflow is
not impacted adversely, which may then result in the overheating of the router and its components.
Not
A dual pole breaker is needed for installation. For determining the recommended breaker size, please
e
adhere to local and national rules and regulations. The breaker size is based on the specifications of the
product for the current drawn and the specified voltage level.
Step 1
Verify that the AC cable is installed in the correct AC source and outlet type.
Step 2
Attach the AC power cable to the cable connector in the AC power module.
Step 3
Place the cable through the opening in the cable clamp.
Step 4
Slide the cable clamp toward the plug.
Step 5
Close the cable clamp on the shoulder of the power cable to secure the power
cable.
Hardware Installation Guide for Cisco CQ211L01 Switch

Connect AC Power to the Chassis

23