Power Supply Unit Input And Output Ranges - Cisco CQ211L01-48H8FH Hardware Installation Manual

Power Supply Unit Input and Output Ranges

Power Supply Unit Input and Output Ranges
Power Supply Restrictions and Considerations
Warning
Warning
Warning
Warning
Observe the following guidelines and limitations:
• Use one type of power supply in a switch.
• The power supply type that is used in the router depends on the type and configuration of the transceivers
• Do not install a mix of AC and DC power supplies in a switch.
• The airflow direction must be the same for all power supply and fan modules in the router.
• The AC-input power supplies support low-line voltage of 120V (Nominal) and high-line voltage of 220V
This table summarizes the list of power supplies' input and output power ranges for different input applications:
Table 6: Input and Output Power Ranges at Low Line, High Line, Low Voltage, and High Voltage Applications
Power Supply Unit
PIDs
S 1 1
Hardware Installation Guide for Cisco CQ211L01 Switch
22
Statement 1030—Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1090—Installation by Skilled Person
Only a skilled person should be allowed to install, replace, or service this equipment. See statement 1089 for
the definition of a skilled person.
Statement 1091—Installation by an Instructed Person
Only an instructed person or skilled person should be allowed to install, replace, or service this equipment.
See statement 1089 for the definition of an instructed or skilled person.
Statement 1073—No User-Serviceable Parts
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
installed in it.
(Nominal). If you need to change voltage type after installation, disconnect the feed from the power
supply before switching the input voltage level.
Supported Routers
C Cisco
CQ211L01
Input Voltage Input Current (Max)
100V -2 0V AC 13A
Installing the Chassis
Output Power
1100W