Table of Contents
Advertisement
Selecting further settings
Adjusting the display brightness
You can adjust the display brightness to
suit the lighting conditions in the room.
In Settings mode , use the or
sensor control to scroll to the
symbol.
Touch OK.
Use the and sensor controls to
select the display brightness you
want.
Touch OK.
Switching off demo mode
Demo mode allows the refrigeration
appliance to be presented by dealers
without the cooling system being
switched on. This setting is not needed
for domestic use.
If demo mode has been switched on
as a default setting, will show on the
display when the refrigeration appli-
ance is switched on.
Touch the OK sensor control on the
control panel.
Miele
will appear initially in the display,
followed by the start screen.
Touch OK.
In Settings mode , use the or
sensor control to scroll to the
symbol.
Touch OK.
After demo mode has been switched
off, the refrigeration appliance switches
off and must be switched on again.
60
Resetting the settings to their default
settings
All settings made on the refrigeration
appliance will be reset to default set-
tings (for settings, see "Guide to the ap-
pliance").
In Settings mode , use the or
sensor control to scroll to the
symbol.
Touch OK.
Use the sensor control to scroll to
the symbol.
Touch OK.
The refrigeration appliance switches off
and must be switched on again.
Information
Appliance data (model identifier and
serial number) is shown on the display.
Keep this appliance data to hand:
- For integrating the refrigeration appli-
ance into your WiFi network (see "Se-
lecting further settings –
Miele@home") (depending on the
model).
- When reporting an appliance fault to
the Miele Customer Service Depart-
ment (see "Service").
- When retrieving information from the
EPREL database (see "Service").
Charcoal filter change indicator
After inserting the charcoal filter (op-
tional accessory), you must activate the
charcoal filter change indicator in
Settings mode .
Advertisement
Table of Contents
