Advertisement
Dispenser Light
The LIGHT pad turns the dispenser light on and
off. When the light is turned off, it will fade out.
The dispenser light will come on automatically
when the dispenser cradle is depressed and will
fade out 5 seconds after it is released. The
LIGHT pad will not turn off the light during
dispensing.
Dispensing Functions
The water, crushed ice, and cubed ice functions
are controlled by the main control board. To
select a function, press the appropriate pad on
the dispenser. The LED will light to identify the
selection.
To dispense ice cubes or crushed ice, choose
the appropriate pad and depress the dispenser
cradle. The solenoid and linkage assembly will
open the ice chute duct door to dispense the
ice. If cubed ice is selected, a solenoid located
behind the ice bucket will lift a rod along the side
of the bucket. This rod pulls a fl apper away
from the cutter blades, allowing cubes to bypass
the ice crusher. The dispenser duct door will
remain open for 3 seconds after dispensing to
allow all ice to clear the chute.
The dispenser light will come on automatically
when the dispenser cradle is depressed and will
fade out 5 seconds after it is released.
Dispenser Lock
When the dispenser system is locked, no
dispenser command will be accepted. This
includes the dispenser cradle and will prevent
accidental dispensing that may be caused
by children or pets. If a pad or the cradle is
depressed with the system locked, it will be
acknowledged with three pulses of the LOCK
LED accompanied by an audible tone.
To lock or unlock communication between the
dispenser and main control board, press the
LOCK pad and hold it for 3 seconds. The LOCK
LED will fl ash while the LOCK pad is pressed.
When the communication is locked, the LOCK
LED will be illuminated.
The status of other functions selected prior to
the initiation of the lock feature will be displayed.
If the lock is engaged while a mode is active, the
LED will remain on until that mode times out.
If the lock is engaged when the fi lter timer
expires, the LED will come on but cannot be
reset until the lock is turned off.
The lock feature will be restored in the event of
a power disruption.
Liner Protection Mode
The dual evaporator model has separate liner
protection modes for each section. The
specific evaporator fan (freezer or fresh food)
will start and run on high speed if the door has
been open for 3 minutes.
This mode is controlled by 2 timers. Timer #1
monitors door-open time. A 3-minute door-open
count begins when the door is opened. If 3
minutes elapse before the door is closed, the
liner protection mode will become active. Once
the door is closed, timer #1 resets and liner
protection mode goes into standby. In standby,
normal fan operation resumes and timer #2
begins a 3-minute door-closed count. If 3 min-
utes elapse without a door opening, liner protec-
tion mode will completely deactivate. If a door is
opened within the timer #2 door-closed count,
the remaining time in the door-closed count will
be deducted from the timer #1 door-open count.
– 10 –
Advertisement
