Same procedure for both blades (whether small or normal sized).
• Blades securing up to Serial Number 420xxxxx
To do that
After inserting the screwdriver in the relevant hole
Tilt the screwdriver handle to the left.
Push the tab that secures the blade downwards.
When the fin has been lowered.
Slide the blade towards the front flange of the drum
Before securing the new blade
Lift up the fin in order to block the blade.
Position the new blade inside the drum guides.
Push it towards the back flange of the drum and check that it is blocked.
If it does not block, repeat the previous operation of lifting up the fin.
108/124
Technical Support - DMM
599 75 58-67 Rev.04