Eliminating Minor Faults Yourself - Bosch GSN54RW40 Instructions For Use Manual

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs greatly
from the set value.
Displays do not illuminate.
Warning signal sounds,
Alarm display lights up.
The freezer compartment
is too warm! Frozen food
is at risk!
Appliance is not cooling,
temperature display and light
are lit.
Automatic super freezing
does not switch on.
Possible cause
Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Appliance is open.
Ventilation openings have
been covered.
Too much food was placed
in the freezer compartment
at once.
Showroom mode is
switched on.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
Connect mains plug. Check whether the power
is on, check the fuses.
To switch off the warning signal, press
the Alarm button. Fig. "/5
Close the appliance.
Ensure that there is adequate ventilation.
Do not exceed max. freezing capacity.
When the fault has been eliminated, the Alarm
display goes out shortly afterwards.
Start appliance self-test (see chapter
"Appliance self-test").
When the programme has ended,
the appliance switches over to normal
operation.
The appliance decides independently whether
automatic Super freezing is required and
automatically switches it on or off.
en
37