Table of Contents
Advertisement
D20E Ethernet I/O Module
Chapter 12: Removing the D20E from
Service
Remove your configuration data and sensitive
information from the D20E
Returning the D20E for maintenance
Prerequisites
D20E ETHERNET I/O MODULE INSTRUCTION MANUAL
Removing the D20E from Service
At some point, it may be necessary to remove the configuration data and sensitive
information from the D20E (for example, disposal purposes).
It may also be necessary to remove data from a PC that has run DAPserver Studio for the
purpose of configuring a D20E Ethernet I/O Module.
When a D20E is to be removed from service, it is necessary to:
•
Remove your configuration data and sensitive information from the D20E
119
•
Remove configuration data on a PC
In the event that it is necessary to remove a D20E from your electrical utility system, you
will want to remove your configuration data and sensitive information from the D20E.
Removal from the system may be due to:
•
Return of device to GE Grid Solutions for maintenance.
•
Device disposal
If the D20E is being returned to GE Grid Solutions for maintenance (that is, RMA), you need
to replace your configuration data with default configuration data prior to shipment.
Prerequisites for removing your configuration data and sensitive information from the
D20E:
•
A Windows PC running the same version of DAPserver Studio that is running on the
D20E.
•
An Ethernet cable.
on page 120
GE INFORMATION
on page
119
Advertisement
Table of Contents
