Table of Contents
Advertisement
30/64
Installation
Bosch Rexroth AG, A15V(L)O Series 11, RE 92511-01-B/2019-10-09
7.3.2 Inside-reservoir installation
Risk of damage with inside-reservoir installation!
To prevent damage to the axial piston unit, all plastic parts (e.g. protective plugs,
covers), except for the tamper-proof caps, must be removed prior to installation in
the reservoir.
▶
Remove all plastic parts, except for the tamper-proof caps, before you install the
axial piston unit in the reservoir. Make sure that no parts of them remain in the
reservoir.
▶
Remove the protective plug from the suction port S and open at least one T port.
Inside-reservoir installation is when the axial piston unit is installed in the reservoir
below the minimum fluid level. The axial piston unit is completely below the
hydraulic fluid.
If the minimum fluid level is equal to or below the upper edge of the pump,
see chapter 7.3.3 "Above-reservoir installation" on page 31.
Axial piston units with electric components (e.g. electric controls, sensors) must
not be installed in a reservoir below the fluid level.
Our advice is to fit a suction pipe to the suction port S and to fit a pipe to drain
port T
In T
to encase. In this case, the other drain port must be plugged.
1
2
The housing of the axial piston unit must be filled before fitting the piping and
filling the reservoir with hydraulic fluid. To prevent draining of the housing,
the reservoir has to be filled with hydraulic fluid as quickly as possible.
4
T
1
T
S
3
T
2
Fig. 10: Inside-reservoir installation A15VO/A15VLO with installation position 4–5
Drain port
, T
, T
T
1
2
3
S
Suction port
SB
Baffle (baffle plate)
NOTICE
5
T
1
SB
h
t min
h
min
h
Minimum required immersion depth
t min
(200 mm)
h
Minimum required distance to
min
reservoir bottom (100 mm)
T
2
S
h
t min
T
3
h
SB
min
Advertisement
Table of Contents
