Table of Contents
Advertisement
Solution 6000
User Guide
have been configured by your installer. See MENU 5-1-1 for
more information.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [5] + [1] + [2].
If the control panel is not programmed to report
using one of the self monitoring formats, the
keypad will display the following:
Reporting format does
not allow user changes.
Contact installer for
further information
If the control panel has been configured to report
via a self monitoring format, the keypad will display
information for telephone number 1.
Phone 1= 0453287306
Phone 2=
Phone 3=
Press
2. Use the [] and [] keys to select the phone number
to add or change, then press [OK] to select.
The keypad will display the following:
Destination 2 Phone 1
0453287306_
Press
3. Use the [] and [] keys to scroll the cursor left and
right across the phone number. Use the [] and []
keys to change the individual digit in the number or
press the [OFF] key to clear the whole number and
then enter the new number using the 0-9 keys.
4. Press [OK] to save and exit, or press [MENU] to
cancel.
Comms > Telephone Numbers >
Call Forward On
When you leave your premises, you no longer need to
remember to manually activate the Call Forward On feature
via the telephone. These addresses allow you to program
the Call Forward On sequence that the control panel will
automatically use to divert your phone when you turn Area
1 'On' .
In Australia, a typical sequence of activating the Call-
Forward On – After Time (All Calls) is described below:
i
For other countries please substitute the appropriate
commands after consultation with your telephone
company.
Note
*61 (To turn Call Forward On – After Time).
32
OK or MENU
0-9 OK to SAVE
MENU 5-1-6
Telephone number that you want calls to go to (e.g.
0416123456).
*5# (End of Call Forward sequence after 5 seconds).
Therefore, you would program as per the following steps to
program the call forward on number as: *610416123456*5#.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [5] + [1] + [6].
The keypad will display information for telephone
number 1.
Call Forward On
*61,*20#
Press
2. Using the numeric keys, enter all the digits of the
call forward on sequence.
You can change a single digit by scrolling the cursor
left [] and right []. For special characters (eg. , =
pause * or # etc), use the [] and [] keys.
3. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Comms > Telephone Number >
Call Forward Off
When you enter your premises, you no longer need to
remember to manually deactivate the Call Forward feature
via the telephone. These addresses allow you to program
the Call Forward Off sequence that the control panel will
automatically use to un-divert your phone when you turn
Area 1 'Off' .
In Australia, a typical sequence of activating the Call
Forward Off feature is described below:
For other countries please substitute the appropriate
i
commands after consultation with your telephone
company.
Note
#61 (To turn Auto-Forward After Time - Off ).
# (End of Call-Forward sequence).
Therefore, you would program as per the following steps to
program the call forward on number as: #61#.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [5] + [1] + [7].
The keypad will display the current call-forward off
sequence.
Call Forward Off
#61#_
Press
OK to SAVE
MENU 5-1-7
OK to SAVE
Bosch Security Systems 3/23 BLCC610U
Advertisement
Table of Contents
