Table of Contents
Advertisement
Solution 6000
User Guide
1. Enter [MENU] + [4] + [9] + [3].
If the system has multiple areas, the keypad will
display a list of areas.
A1 Security System
A2 Area 2 Name
A3 Area 3 Name
Press
2. Use the [] and [] keys to select the area that
you want to test the fire sirens in, then press [OK].
Alternatively, you can enter the area number, then
press [OK].
The keypad will display the following during the fire
siren test.
Fire Audible Testing
Press any key to abort
Press OK or MENU
When the test is complete, the keypad will display
the following:
Testing Complete. Press
OK to continue
Press OK or MENU
3. Press [OK] to exit.
Communication / Reporting
Programming options in this section relate to how you
alarm system will communicate alarm information.
Your installer will advise you on the exact makeup and
configuration of your system.
Comms > Commands >
Call/Answer RAS
This menu allows you to initiate a modem call to the
installer's off-site computer for programming changes or
updates. Your installer may request that you enter this
command so that they can remotely service and configure
your system. You should not enter this command unless
requested to do so.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [5] + [0] + [1].
Comms > Commands >
Call Forward On/Off
This menu allows you to turn on and off the call forward
feature. When you turn on call forwarding, the control
panel will automatically activate and de-activate the call
forward on and call forward off sequence accordingly
when you turn Area 1 All On and off (arm and disarm).
30
OK or MENU
MENU 5-0-1
MENU 5-0-2
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [5] + [0] + [2].
If the call forward status is off, the keypad will
display:
Call Forward On/Off
Call Forward is OFF.
To turn ON, Press ON.
To Go Back Press OK
If the call forward status is on, the keypad will
display:
Call Forward On/Off
Call Forward is ON.
To turn OFF, Press OFF.
To Go Back Press OK
2. To toggle call forward on, press the [ON] key or press
the [OFF] key to turn call forward off.
3. Press [OK] to save and exit, or press [MENU] to
cancel.
The call forward on/off can be used to automatically
i
divert your home phone to you mobile phone when
Note
the system is armed and automatically cancel the
diversion when the system is turned off. See MENU
5-1-6 for more details.
Comms > Commands >
Check Web Email
Reserved for future use
Comms > Commands >
Email System Log
Reserved for future use
Comms > Commands >
Start Direct Connect
This menu allows the master user to start a direct link
session. You should discuss this option with your installer.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [5] + [0] + [5].
Comms > Commands >
Voice Setup
This menu allows the master user to record their own
customised greeting and zone description messages
that will be played back to users that are programmed to
receive voice reports from the alarm system.
Messages should clearly describe the premises and zones
so that the user receiving the telephone call from the
MENU 5-0-3
MENU 5-0-4
MENU 5-0-5
MENU 5-0-6
Bosch Security Systems 3/23 BLCC610U
Advertisement
Table of Contents
