Dethatching unit for greensmaster 3000 series traction unit (16 pages)
Summary of Contents for Toro Greensmaster TriFlex 3300 Series
Page 1
Form No. 3445-366 Rev A Dethatching Unit Greensmaster ® 3300/3400 Series TriFlex ® Traction Unit Model No. 04720—Serial No. 408000000 and Up *3445-366* Register at www.Toro.com. Original Instructions (EN)
Page 2
Model No. Whenever you need service, genuine Toro parts, or additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model Serial No. and serial numbers of your product ready. Figure 1...
Toro distributor. • To ensure optimum performance and continued safety certification of the machine, use only genuine Toro replacement parts and accessories. Replacement parts and accessories made by other manufacturers could be dangerous, and such use could void the product warranty.
Make all necessary repairs before resuming operation. • Keep all parts in good working condition and all hardware tightened. Replace all worn or damaged decals. • Use only accessories, attachments, and replacement parts approved by Toro.
Setup With the rear roller contacting the level surface, loosen both height-of-cut nuts. Rotate the height-of-cut until both ends of the front roller contact the level surface. Verify contact by using a piece of paper to check each roller end. Installing the Front Roller Tighten both height-of-cut knob locknuts.
Tighten both height-of-cut knob locknuts. Installing the Electrical Counterweight Installing the Dethatching Unit No Parts Required No Parts Required Procedure Note: If the dethatching unit is installed on a machine Procedure with electric reel motors, you must install an additional electrical counterweight to the existing counterweight.
To ensure optimum performance and continued safety certification of the machine, use only genuine Toro replacement parts and accessories. Replacement parts and accessories made by other manufacturers could be dangerous, and such use could void the...
Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Disassembling the Reel Disassemble the reel whenever you need to change a blade or replace the reel bearings. Important: Ensure that the 2 shaft retainers and spacer are in place before installing the bearing on the reel (Figure...
The Roller Rebuild Tool Kit includes all the tools and the installation instructions required to rebuild a roller with the roller rebuild kit. Refer to your parts catalog or contact your authorized Toro distributor for assistance. g346125 Figure 7 5.
Page 11
The method of transmission shall be electronic transmittal. This machinery shall not be put into service until incorporated into approved Toro models as indicated on the associated Declaration of Conformity and in accordance with all instructions, whereby it can be declared in conformity with all relevant Directives.
Page 12
Countries Other than the United States or Canada Customers who have purchased Toro products exported from the United States or Canada should contact their Toro Distributor (Dealer) to obtain guarantee policies for your country, province, or state. If for any reason you are dissatisfied with your Distributor's service or have difficulty obtaining guarantee information, contact your Authorized Toro Service Center.