Bore drive head for compact utility loaders (12 pages)
Summary of Contents for Toro 04720
Page 1
Form No. 3402-426 Rev A Dethatching Unit Greensmaster ® 3300/3400 Series TriFlex ® Traction Unit Model No. 04720—Serial No. 315000001 and Up *3402-426* A Register at www.Toro.com. Original Instructions (EN)
Page 2
(Figure which signals a hazard that may cause serious injury or death You may contact Toro directly at www.Toro.com for product if you do not follow the recommended precautions. and accessory information, help finding a dealer, or to register your product.
• Perform only those maintenance instructions described in this manual. If major repairs are ever needed or assistance is desired, contact an Authorized Toro Distributor. • To ensure optimum performance and safety, always purchase genuine Toro replacement parts and accessories.
Never use "will-fit" replacement parts and accessories made by other manufacturers. Look for the Toro logo to assure genuineness. Using unapproved replacement parts and accessories could void the warranty of The Toro Company. Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger.
Setup 4. Rotate the height-of-cut until both ends of the front roller contact the level surface. 5. Verify contact by using a piece of paper to check each roller end. 6. Tighten both height-of-cut knob locknuts. Installing the Front Roller No Parts Required Adjusting the Reel Blades Procedure...
Page 6
Installing the Dethatching Reel No Parts Required Procedure See the traction unit Operator’s Manual for installing the reel to the machine. Important: If you set the dethatching reel at a negative setting, take care to prevent damaging the reel blades due to contact with concrete floors or paved surfaces.
Note: Determine the left and right sides of the machine available for use with the machine to enhance and expand from the normal operating position. its capabilities. Contact your Authorized Service Dealer or Distributor or go to www.Toro.com for a list of all approved attachments and accessories.
Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Disassembling the Reel Disassemble the reel whenever you need to change a blade or replace the reel bearings. Important: Ensure that the 2 shaft retainers and spacer are in place before installing the bearing on the reel (Figure 5).
Page 10
The method of transmission shall be electronic transmittal. This machinery shall not be put into service until incorporated into approved Toro models as indicated on the associated Declaration of Conformity and in accordance with all instructions, whereby it can be declared in conformity with all relevant Directives.
Page 11
The Way Toro Uses Information Toro may use your personal information to process warranty claims, to contact you in the event of a product recall and for any other purpose which we tell you about. Toro may share your information with Toro's affiliates, dealers or other business partners in connection with any of these activities. We will not sell your personal information to any other company.
Page 12
Countries Other than the United States or Canada Customers who have purchased Toro products exported from the United States or Canada should contact their Toro Distributor (Dealer) to obtain guarantee policies for your country, province, or state. If for any reason you are dissatisfied with your Distributor's service or have difficulty obtaining guarantee information, contact the Toro importer.