Table of Contents
Advertisement
en Basic operation
Notes
¡ If you are using mineral water, set the water hard-
ness range to "very hard". If you are using mineral
water, you must only use non-carbonated mineral
water.
Setting
1
0 (softened)
1 (soft)
2 (medium)
3 (hard)
2
4 (very hard)
1
Only set this if you will be using solely softened water.
2
Also set for mineral water. Only use non-carbonated mineral water.
7.2 Performing initial start-up
After connecting the appliance to the power supply,
you must configure the settings for its initial start-up. It
may take a few minutes for the settings to appear on
the display.
Press
to switch the appliance on.
1.
a The first setting appears.
To change the setting as required, press a value in
2.
the list or change the value using the setting ring.
Possible settings:
– Language
– Home Connect → "Home Connect ", Page 25
– Time
→ "Setting the time", Page 24
– Water hardness
→ "Determining the water hardness before
switching on the appliance for the first time",
Page 11
Press
and switch to the next setting.
3.
Work through the settings and make changes as re-
4.
quired.
a After the last setting, a message appears on the dis-
play confirming that the initial start-up is complete.
To check the appliance before heating for the first
5.
time, open and close the appliance door once.
7.3 Cleaning the appliance before using it
for the first time
Before using the appliance to cook food for the first
time, you must clean the cooking compartment and ac-
cessories.
Remove the product information and the accessor-
1.
ies from the cooking compartment. Remove any
leftover packaging, such as polystyrene pellets, and
any adhesive tape that is in or on the appliance.
8 Basic operation
8.1 Switching on the appliance
Press
to switch the appliance on.
▶
a The display shows the menu.
12
¡ If your tap water is very hard, we recommend that
Water hardness in
mmol/l
-
Up to 1.5
1.5-2.5
2.5-3.8
Over 3.8
2.
3.
4.
5.
6.
a When the time has elapsed, a signal sounds. A
7.
8.
9.
10.
8.2 Switching off the appliance
Switch your appliance off when you are not using it.
The appliance will switch itself off automatically if it is
not used for a certain period of time.
▶
you use softened water. If you are using only
softened water, set the "softened" water hardness
range.
German hardness °dH
-
Up to 8.4
8.4-14
14-21.3
Over 21.3
Wipe the smooth surfaces in the cooking compart-
ment with a soft, damp cloth.
Press
to switch the appliance on.
Fill the water tank.
→ "Filling the water tank", Page 16
Apply the following settings:
Type of heating
Temperature
Added steam
Cooking time
→ "Basic operation", Page 12
Start the operation.
Ventilate the kitchen while the appliance is heat-
‒
ing.
message appears on the display confirming that the
operation has finished.
Press
to switch the appliance off.
Once the appliance has cooled down, clean the
smooth surfaces in the cooking compartment with a
detergent solution and a dish cloth.
Clean the accessories thoroughly using a detergent
solution and a dish cloth or soft brush.
Empty the water tank and dry the cooking compart-
ment.
→ "After using steam operation", Page 18
Press
to switch the appliance off.
French hardness °fH
-
Up to 15
15-25
25-38
Over 38
4D hot air
Maximum
3
1 hour
Advertisement
Table of Contents
