Cuisinart baby CPS-100 Series - Baby Portable UV Sterilizer Manual

IMPORTANT SAFEGUARDS

For your safety and continued enjoyment of this product, always read the instruction book carefully before using.

1. READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE.
2. KEEP OUT OF THE REACH OF CHILDREN.
3. DO NOT SUBMERGE IN WATER OR ANY TYPE OF LIQUID.
4. DO NOT LOOK AT UV LIGHT WHILE IN OPERATION.
5. DO NOT USE IF BROKEN OR DAMAGED.
6. DISPOSE OF BATTERIES AND UNIT ACCORDING TO LOCAL LAWS.
7. DO NOT USE WHILE BATHING. NEVER USE WHILE SLEEPING OR DROWSY.
   
   To reduce the risk of fire, electric shock, or injury:
   1. Do not allow to be used as a toy. Close attention isnecessary when used by or near children.
   2. Use only as described in this manual. Use only manufacturer's recommended attachments.
   3. 
      This cover is provided with an interlock to reduce the risk of excessive ultraviolet radiation. Do not defeat its purpose or attempt to service without removing

SAVE THESE INSTRUCTIONS
Declaration of conformity to the applicable provisions of applicable US Federal requirements, including 21 CFR, Chapter 1, Subchapter J, Radiological Health.
FOR HOUSEHOLD USE ONLY

STERILIZER USE INSTRUCTIONS

1. Insert 3xAAA alkaline batteries into battery compartment (look for the symbol on unit for correct battery placement).
2. Open door by sliding the front cover from left to right.
3. Insert pacifi er into clips located inside unit cavity and/or remove clips by grabbing and pulling rubber clips out of unit to insert objects like bottle nipples and other baby accessories.
4. Close door.
   Note: To re-insert clips: Hold the rubber clip so the word "UP" is parallel to the side wall of the unit.
   Insert the "T" section of rubber clip into the square hole in the back of the chamber. Rotate and twist the rubber clip so that the word is up and the angle section faces inward.
5. Press and hold the side button for 2 seconds to begin process. The LED light stays on.
6. The sanitizing process will take up to 6 minutes. Note: It may take up to 30 seconds for bulb to illuminate.
7. During the sanitizing process, unit automatically shuts off when door is open.
8. Unit automatically shuts off when cycle is complete.
9. Press and hold the button for 2 seconds to end the process.
10. Three quick blinks followed by a 3-second pause indicates the batteries are low.
11. Any other services should be performed by an authorized service representative.

CLEANING DIRECTIONS

To clean inside unit:

1. Use a damp cloth to wipe down all internal surfaces of unit. Use water only.
2. DO NOT Immerse in water.