Panasonic KX-TVM50 Installation Manual page 128

5.2.3 PBX Parameters
Inband Signalling
These parameters are used when the Integration Mode is set to Inband. If the PBX type is set to a KX-T
series system, these parameters will be automatically set. If another type of PBX is used, check the system's
Installation Manual for settings.
Code (default)
Ringback Tone
1
Busy Tone
2
Reorder Tone
3
DND
4
Answer
5
Forwarded to Voice Mail
(Ringing)
6
Forwarded to Voice Mail
(Busy)
7
Forwarded to Extn.
8
Confirmation Tone
9
Disconnect
#9
Digit Translation Table Parameters
These parameters allow PBXs that have a fixed Follow-on ID sequence to be used with the VPS. For example,
a Follow-on ID sequence of [
• Inter-Digit Timeout
This parameter defines the interval of incoming signals (Follow-on ID) from the PBX to the VPS.
• Translation Table
When the system receives digits within the inter-digit time, it checks them against the input table. If they
are found, the VPS translates the digits according to the table.
128 Installation Manual
Call State
The extension dialled is ringing.
The extension dialled is busy.
An invalid extension number is dialled or the call is inadver-
tently connected to another Voice Mail port (also heard when
no DTMF receiver is available to the Voice Mail extension).
The extension dialled has set the Do Not Disturb feature
(DND).
The extension dialled is answered.
The extension dialled is forwarded to Voice Mail and another
Voice Mail port is able to answer. (This lets the first Voice Mail
port, usually an Auto Attendant, send the call to the other
Voice Mail port.)
The extension dialled is forwarded to Voice Mail and no other
Voice Mail ports are available to accept the call. (This signals
the Voice Mail port, usually Auto Attendant, to let the caller
leave a message.)
The extension dialled is forwarded to another non-Voice Mail
extension.
The Message Waiting Lamp On or Message Waiting Lamp
Off code is dialled successfully.
The caller disconnects. The telephone company must set a
CPC signal to the PBX line for this signal to work for trunk
calls.
1001] can be changed to [#61001] by using these parameters.
Sent to the Voice Mail Port When...
Document Version 2.1 2008/04