Faults And What To Do About Them - Bosch WAE28262GB Instruction Manual And Installation Instructions

Faults and what to do about them.

en
Faults and what to do about them.
Faults
Water is running out.
Water not flowing in.
Detergent is not being dis-
pensed.
The door cannot be
opened.
Programme does not
start.
The water is not draining.
Water is not visible in the
drum.
The spin result is not sat-
isfactory.
Laundry wet/too damp.
The spin cycle runs sev-
eral times.
The programme is taking
longer than usual.
The length of the pro-
gramme changes during
the wash cycle.
Residual water in the care
product dispenser.
There are odours or
greasy deposits in the
washing machine.
N Wash/Active indica-
tor light flashes. Foam
may also be leaking from
the detergent drawer.
24
Cause/remedy
Attach the drain hose correctly or replace it. ~ Page 30
■
Tighten the threaded joint on the inlet hose. ~ Page 29
■
Has the Start button been pressed?
■
Is the tap turned on? ~ Page 29
■
Could the filter be clogged? Clean the filter. ~ Page 22
■
Is the inlet hose kinked or trapped?
■
The safety function is activated. Stop programme? ~ Page 18
■
- - - - Rinse Stop (without final spin) selected?
■
Can the door only be opened by the emergency release? ~ Page 23
■
Has the Start button been pressed to pause the programme, or has the
■
Ready in time been selected?
Is the door closed?
■
Is @ (childproof lock) activated? Deactivate. ~ Page 18
■
- - - - Rinse Stop (without final spin) selected?
■
Clean the drain pump. ~ Page 21
■
Clean the drain pipe and/or the drain hose.~ Page 22
■
Not a fault – the water is below the visible area.
■
Not a fault – the unbalanced load detection system has interrupted the spin
■
because the laundry is unevenly distributed.
Distribute small and large items of washing in the drum.
Programme for p Easy-Iron selected?
■
Is the selected speed too low?
■
Not a fault – the unbalanced load detection system is adjusting an imbal-
■
ance.
Not a fault – the unbalanced load detection system is adjusting an imbal-
■
ance by repeatedly distributing the laundry.
Not a fault; the foam detection system is active – a rinse cycle has been
■
switched on.
Not a fault – the programme sequence is optimised for the specific washing
■
process. This may change the length of the programme shown in the dis-
play panel.
Not a fault – the effectiveness of the care product is not affected.
■
If necessary, clean the insert and detergent drawer. ~ Page 20
■
Run the Cottons 90 °C programme without any laundry. Use standard
■
detergent for this.
Have you used too much detergent? Mix one tablespoon of fabric softener
■
with 1/2 litre of water and pour into compartment II (not for outdoor fabrics
or those made with down). Use less detergent in the next washing cycle.