Table of Contents
Advertisement
Programme default settings
en
0
Programme default
settings
You can find possible
Note:
P r o g r a m m e d e f a u l t s e t t i n g s
programme default settings in the
overview; these differ depending on the
model.
The programme default settings for all
programmes are preset at the factory
and are displayed in the display panel
after the programme is selected.
°C Temperature
(s Temp. °C)
Depending on the programme
progress, you can change the preset
washing temperature (in °C) before and
during the programme.
Press the temperature button repeatedly
until the required temperature is
displayed in the display panel.
The maximum temperature that can be
set depends on the programme that has
been selected.
Programme overview ~
Supplementary sheet for the installation
and operating instructions
0 Spin speed
(Spin, rpm, 0)
Depending on the programme
progress, you can change the spin
speed (in rpm; revolutions per minute)
before and during the programme.
To do this, press the Spin Speed button
repeatedly until the required spin speed
is displayed in the display panel.
The maximum speed that can be
selected depends on the model and
programme that has been selected.
14
- - - - Rinse Stop setting (without final
spin). The laundry remains in the water
after the last rinse cycle.
You can select - - - - Rinse Stop (without
final spin) to prevent creasing if the
laundry is not taken out of the washing
machine immediately after the
programme has ended.
Programme overview ~
Supplementary sheet for the installation
and operating instructions
5 Ready in
(Finished in, 5, 4, 3)
The respective programme length is
displayed by selecting the programme.
The length of the programme is
automatically adjusted when the
programme is running. Changes to the
programme default settings or
additional programme settings also
change the programme length.
Before starting the programme, the
programme end ("Ready in" time) can
be preselected in increments of one
hour (h = hours) up to a maximum of 24
hours.
Select the required programme.
1.
The programme duration is
Note:
displayed in the display panel.
Press the Ready in button
2.
repeatedly until the required number
of hours is displayed in the display
panel.
Press the Start button.
3.
The set "Ready in" time is now active.
The selected programme starts
automatically and ends after the
selected number of hours.
After the programme has started, the
programme duration, e.g. 2:30
(hours:minutes), is displayed in the
display panel.
Advertisement
Table of Contents
