Table of Contents
Advertisement
VI.
How to use the EEPROM Copy Jig
The TXFLIG02SER EEPROM copy jig is used to copy the TV data to / from the jig
(temporary storage) in the extended service mode. This is useful if the replacement DG
board does not have the same data as the old DG board.
Procedure:
Refer to figure 50.
1.P
lug the TXFJIG02SER copy jig into the digital b
2.E
nter the extended service mode and highligh
3.S
elect it by pressing on the Action button.
4.F
rom the new menu, choose ALL to copy all the data, ADJ to c
adj
ustment data, or FIX to copy the fixed data. *
5
.Transfer the selected data to
A
ction.
6
.Transfer the selected data from
p
ressing Action.
Transfer data
in or out of the
jig by
selecting a
direction
the jig by highlighting "IN—EX" and select it by pressing
the jig by highlighting "EX—IN" and select it by
Data
transfer
Figure 50 - EEPROM jig hookup and operation
53
oard at unused DG10 socket.
t "Area" (use the Vol / Ch buttons).
opy only the
To DG10
TXFJIG02SER
EPROM jig
Advertisement
Table of Contents
