Bosch MultiTalent 3 Instruction Manual page 13

■ When adding contents which are to be
sliced or shredded, apply only light pres-
sure to the pusher. Remove the pusher
and add ingredients through the feed tube.
Warning!
Empty the bowl before it becomes so full
that the cutting or grating contents reach the
carrier disc.
After using the appliance
■ Set the rotary switch to P.
■ Remove mains plug.
■ Rotate the lid in an anti-clockwise direction
and remove.
■ Remove tool:
Take tool holder together with universal
blade, whisking disc or kneading hook out
of the bowl. Remove the tools from the tool
holder.
■ Take out the cutting discs by the plastic
stud in the centre. Take tool holder out of
the bowl.
■ Rotate bowl anti-clockwise and remove.
■ Clean all parts, see "Cleaning and
servicing".
Blender
Blade insert with blender/cutting blade for
mixing liquid or semi-solid food, for cutting/
chopping raw fruit and vegetables, for purée-
ing food.
W Risk of injury from sharp blades /
rotating drive!
Never place fingers in the attached blender!
Do not remove/attach the blender until the
drive is at a standstill. Do not touch blades of
the blade insert with bare hands. Clean them
with a brush.
W Risk of scalding!
If processing hot liquids, steam escapes
through the funnel in the lid. Add a max.
0,4 litres of hot or frothing liquid.
Warning!
Blender may be damaged. Do not process
deep-frozen ingredients (except ice cubes).
Do not operate blender when empty.
Fig. D
■ Place seal on the blade insert. Ensure that
the seal is positioned correctly.
Important information
If the seal is damaged or not correctly
positioned, liquid may run out.
■ Insert blade insert with blender/cutting
blade p into the blender jug and lock
anti-clockwise (m). Rotate the blade insert
at least until the arrow matches up with the
marking on the blender jug.
■ Turn blender jug over (blade insert face
down).
■ Attach the blender jug (match arrow on the
jug to the dot on the appliance .) and
rotate as far as possible in a clockwise
direction (,).
■ Add ingredients.
Maximum capacity, liquid = 1.0 litres (froth-
ing or hot liquids max. 0.4 litres). Optimal
processing capacity –
solids = 80 g.
■ Attach lid and press firmly. Hold lid while
working.
■ Insert the mains plug.
■ Set the rotary switch to the desired setting.
■ To add more ingredients, set the rotary
switch to P.
■ Remove the lid and add ingredients
or
■ remove the funnel and gradually add solid
ingredients through the refill opening
or
■ pour liquid ingredients through the funnel.
After using the appliance
■ Set the rotary switch to P.
■ Remove mains plug.
■ Rotate the blender in an anti-clockwise
direction and remove.
■ Remove lid.
■ Loosen blade insert clockwise (l) and
remove from the blender jug.
■ Clean all parts, see "Cleaning and
servicing".
Universal cutter
Use (depending on model):
– With the blade insert with blender/cutting
blade p for cutting and chopping meat,
hard cheese, onions, herbs, garlic, fruit,
vegetables.
Operation en
13