Table of Contents
Advertisement
AUTODOME 7100i│AUTODOME 7100i IR
1.4
Important Safety Instructions
Read, follow, and retain for future reference all of the following safety instructions. Follow all
warnings before operating the device.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Protect all connection cables from possible damage, particularly at connection points.
* Refer to chapter "Installing the camera outdoors" in the Installation Manual.
Caution!
To reduce the risk of electric shock and damage to the product, only connect any power
!
source when the device is fully installed.
Caution!
Installation must be made by qualified personnel and conform to ANSI/NFPA 70 (the National
!
Electrical Code
and all applicable local codes. Bosch Security Systems accepts no liability for any damages or
losses caused by incorrect or improper installation.
Warning!
INSTALL EXTERNAL INTERCONNECTING CABLES IN ACCORDANCE TO NEC, ANSI/NFPA70
(FOR US APPLICATION) AND CANADIAN ELECTRICAL CODE, PART I, CSA C22.1 (FOR CAN
APPLICATION) AND IN ACCORDANCE TO LOCAL COUNTRY CODES FOR ALL OTHER
!
COUNTRIES. BRANCH CIRCUIT PROTECTION INCORPORATING A 20 A, 2-POLE LISTED
CIRCUIT BREAKER OR BRANCH RATED FUSES ARE REQUIRED AS PART OF THE BUILDING
INSTALLATION. A READILY ACCESSIBLE 2-POLE DISCONNECT DEVICE WITH A CONTACT
SEPARATION OF AT LEAST 3 mm MUST BE INCORPORATED.
Warning!
ROUTING OF EXTERNAL WIRING MUST BE DONE THROUGH A PERMANENTLY EARTHED
!
LIQUID TIGHT METAL CONDUIT.
Notice!
i
Outdoor installation
For details about the proper configuration for installing your camera outdoors with surge and
lightning protection, refer to the chapter " Installing the camera outdoors, page 17 ."
Bosch Security Systems
Clean only with a dry cloth. Do not use liquid cleaners or aerosol cleaners.
Do not install device near any heat sources such as radiators, heaters, stoves, or other
equipment (including amplifiers) that produce heat.
Never spill liquid of any kind on the device.
Take precautions to protect the device from power and lightning surges.*
Adjust only those controls specified in the operating instructions.
Operate the device only from the type of power source indicated on the label.
Unless qualified, do not attempt to service a damaged device yourself. Refer all servicing
to qualified service personnel.
Install in accordance with the manufacturer's instructions in accordance with applicable
local codes.
Use only attachments/accessories specified by the manufacturer.
®
(NEC)), Canadian Electrical Code, Part I (also called CE Code or CSA C22.1),
Installation Manual
Safety | en
5
2023-02 | V01 |
Advertisement
Table of Contents
