Table of Contents
Advertisement
AUTODOME 7100i│AUTODOME 7100i IR
NDA-7100-PIPEF
NDA-7100-PENF
7.
8.
9.
10. Attach the hook of the camera to the pin on the mount.
11. Tilt the camera until you connect the camera to the mount.
12. Tighten the top cap screws.
13. Tighten the screws to 10-12 Nm.
14. Apply power.
Bosch Security Systems
1
Use a Torx wrench to install a grounding screw (user-supplied) on the grounding
connection point on the bottom of the pipe mount, as in the figure that follows.
Tighten the screws.
Remove the protective caps, as in the figure that follows.
Installation Manual
Installing a pipe mount | en
2023-02 | V01 |
31
Advertisement
Table of Contents
