Control Panel Leds; Drive Carrier Leds - Bosch DIVAR IP 6000 2U Installation Manual

12 en | System overview
2.3.2

Control panel LEDs

The control panel located on the front of the chassis has LEDs to provide you with critical
information related to different parts of the system. This section explains what each LED
indicates.
–
–
–
–
–
–
2.3.3

Drive carrier LEDs

Your chassis uses SAS/SATA.
SAS/SATA drives
Each SAS/SATA drive carrier has two LEDs.
–
–
2014.01 | V2 | DOC
Power failure: A flashing LED indicates a power failure in the power supply.
Overheat/fan fail: A flashing LED indicates a fan failure.
When continuously on (not flashing) the LED indicates an overheat condition, which may
be caused by cables obstructing the airflow in the system or the ambient room
temperature being too warm. Check the routing of the cables and make sure all fans are
present and operating normally. You should also check to make sure that the chassis
covers are installed. Finally, verify that the heat sinks are installed properly.
This LED will remain flashing or on as long as the fan failure/overheat condition exists.
NiC2: A flashing LED indicates network activity on GLAN2.
NIC1: A flashing LED indicates network activity on GLAN1.
HDD: A flashing LED indicates IDE channel activity in the SAS/SATA drive, SCSI
drive, and/or DVD-ROM drive activity.
Power: Indicates power is being supplied to the system's power supply units.
This LED should normally be illuminated when the system is operating.
Green: Each Serial ATA drive carrier has a green LED. When illuminated, this green LED
(on the front of the SATA drive carrier) indicates drive activity. A connection to the SATA
backplane enables this LED to blink on and off when that particular drive is being
accessed.
Red: The red LED indicates a SAS/SATA drive failure. If one of the SAS/SATA drives fail,
you should be notified by your system management software.
Installation Manual
DIVAR IP 6000 2U
Bosch Sicherheitssysteme GmbH