Target Detection Input - Panasonic LP-RF Series Setup & Maintenance Manual

4-6-9 Target detection input

READY OUT (Y5)
TRIGGER IN (X5)
TARGET DETECTION IN (X7)
PROCESSING OUT (Y10)
LASING OUT (No.40)
PROCESSING END OUT (Y11)
PROCESSING FAIL OUT (Y12)
CHECK OK OUT (No.34)
CHECK NG OUT (No.35)
WARNING OUT (Y14)
Item Time
T1 2ms or more
T2 0 to 9999 ms
T3 1 ms or more
T4 2 to 510 ms
T5 2 to 510 ms
T6 Approx. 3 sec.
• Before using TARGET DETECTION IN (X7), set X7: TARGET DETECTION IN to "Enabled" at the system settings of
Laser Marker NAVI smart.
116
ON
OFF
ON
T1
OFF
ON
T3
OFF
ON
OFF
ON
T2
OFF
ON
T4
OFF
ON
OFF
ON
T5
OFF
ON
OFF
ON (Normal)
OFF (Error)
Remarks
Keep the ON status for 2ms or more.
When the trigger delay time is set in the selected file, trigger processing (lasing) operation
starts after the delay time.
When TARGET DETECTION IN (X7) turns ON for more than 1ms while LASING OUT
(No.40) is ON, it is judged as success of the target detection.
This is the output to notify that the marking trigger processing completed normally. Even
when the workpiece could not be detected, PROCESSING END OUT (Y11) turns on unless
the trigger processing operation is interrupted. This is One-shot output. Set the output time
on System settings screen. There is a small margin of error for the setting value.
According to the ON/OFF state of TARGET DETECTION IN (X7), CHECK OK OUT (No.34)
or CHECK NG OUT (No.35) turns on for one-shot time after the trigger processing (lasing)
operation. The one-shot output time is set on the system settings screen. There is a small
margin of error for the setting value.
• When TARGET DETECTION IN (X7) turns ON for more than 1ms during lasing
operation: CHECK OK OUT (No.34) turns ON.
• When TARGET DETECTION IN (X7) did not turn ON during lasing operation: CHECK
NG OUT (No.35) turns ON.
When TARGET DETECTION IN (X7) did not turn ON during lasing operation, the warning
E752 is output for 3 seconds.
ME-LPRF-SM-11
T1
T3
T2 T2
T4
T5
T4
T5
T6