Table of Contents
Advertisement
34/60
Start-up
Bosch Rexroth AG, MIT: HQ 5/H, HQ 5/XH, 3 842 558 544/2017-07
8 Start-up
8.1 Initial start-up
Sudden movements, falling workpiece pallets
Risk of injury caused by sudden movements and falling objects.
Make sure that the product has been installed properly by qualifi ed personnel
(see page 8) before starting it up.
Malfunctions due to incorrect assembly and start-up
The product can get damaged and its service life shortened.
Commissioning requires basic mechanical, pneumatic and electrical knowledge.
The product may only be commissioned by qualifi ed personnel (see page 8).
• Before the initial start-up or re-commissioning of a conveyor system, run a risk
assessment in accordance with DIN EN ISO 12100.
• Before the initial start-up, make sure there are no protruding or sharp-edged parts
that may be a hazard to personnel working or moving in the area.
• According to EU Machinery Directive 2006/42/EC, you must equip the transfer
system with EMERGENCY STOP devices.
• The surfaces of motors and gears can reach temperatures of over 65 °C under
certain load and operating conditions. In these cases, you must comply with the
respective applicable accident prevention regulations (UVV) by taking appropriate
constructive measures (safety guards) or by affi xing/displaying appropriate warning
signs!
• Make sure that all the electrical and pneumatic connections are either in use
or covered. Make sure that all bolted connections and plug-in connections are
properly seated. All relevant protective covers must be fi tted.
• Only inspect and adjust continuous conveyors that are in motion or operation when
the safety guards are in place.
• Note DIN EN ISO 13857 when you remove or replace safety guards and/or bypass
safety equipment.
• Test runs with open paneling should only be performed by a person with
appropriate knowledge and experience using tip switches, and if there is no
possibility of interference from other switching devices.
• Only start up the product if all safety equipment has been installed in the system
and is functional.
• Only start up a product that has been completely installed.
CAUTION
NOTICE
Advertisement
Table of Contents
