Panasonic WJ-SX 150A Operating Instructions Manual page 67

1. Move the cursor with the joystick to the desired area,
and then press the CAM (SET) key. Setting point 1 is
determined.
Note: If you control the joystick while holding down the
SHIFT button, the cursor will move by 10 steps.
C01 LOW
C01 LOW
Logical camera number and sensitivity level will move
when a cursor points here. (The default position is
here.)
2. Move the "+" mark to the desired area, and then press
the CAM (SET) key. Setting point 2 is determined and
the "+" mark will disappear. Then, the mark will appear
again at the center of the monitor. The square, covered
with Setting point 1 and 2, is showing the motion-detec-
tion area.
Note: White images will be displayed in the square if the
currently selected channel has no camera connection.
C01 LOW
3. To configure more motion-detection area, repeat Step 1
and 2.
4. To set the motion-detection area of another camera,
press the NEXT or PREV button. Then, select the
desired logical camera number. The live image of the
selected camera will be displayed.
70
+
+
Setting point
Setting point 2
+
Setting point 1
Notes:
• If you repeat Step 1 after setting 4 motion-detection
areas, "NG" will blink at the center of the monitor for
two seconds.
• To reset a motion-detection area, move the "+"
mark on the desired area. Then, press the CLEAR
button. The area will be reset.
• If an area overlaps another one, the newer area will
be reset.
5. To configure the motion-detection areas of another
camera channel, press the NEXT or PREV button.
6. Repeat Step 1 to 4.
Notes:
• If you press the CLEAR button while holding down the
SHIFT button, all the motion-detection areas of the cam-
era channel will be cleared.
• Depending on the sensitivity level, a motion-detection
area needs the following area sizes.
Sensitivity
LOW
MID
HIGH
You can change the sensitivity level in WJ-SX150A
Administrator Console (Refer to p. 89.) The factory default
setting is LOW.
After the configuration, press the MON (ESC) button. The
motion-detection setting will be memorized and the monitor
display will return to the previous menu.
After all the configurations, press the SETUP button while
holding down the SHIFT button. The configuration will be
updated when closing SETUP MENU.
Area size
17 x 17 steps or more
12 x 12 steps or more
5 x 5 steps or more