Setting Up A Frequency Output - GE AquaTrans AT868 Abridged Manual

September 2004
Setting Up a Frequency
Output
2-16
1. At Output B or D , select OFF or FREQ and press [ENTER] .
2. Do one of the following:
•
If you selected OFF , the meter returns to the Global I/O menu.
Go to Setting Up a Totalizer Output on the next page.
•
For 1-channel meter, go to step 4.
•
For a 2-channel meter, go to step 3.
3. At Channel , press [ ] to select the desired channel and press
[ENTER] .
4. Press [ ] to select the desired measurement parameter and press
[ENTER] .
Note: The measurement units that appear in these prompts are those
selected in the GLOBL-SYSTM
5. At BASE , enter a value for the low end of the output range
(-2,000,000 to 2,000,000) by using the arrow keys. Press [
[ ] to move the cursor to the desired location and press
[ ]
to increase or decrease the number. Then press [ENTER] .
6. At FULL , enter a value for the high end of the output range
(-2,000,000 to 2,000,000) by using the arrow keys. Press [
[ ] to move the cursor to the desired location and press
[ ]
to increase or decrease the number. Then press [ENTER].
7. At FULL SCALE FREQ , enter a value for the full scale of the output
(between 10 to 100,000) by using the arrow keys. Press [
[ ] to move the cursor to the desired location and press
[ ]
to increase or decrease the number. Then press [ENTER].
8. At Error handling, press [ ] to select the desired option for
handling errors ( HOLD, LOW, HIGH , or OTHER ) and press [ENTER] .
9. If OTHER is selected, the Error frequency display appears. This
allows the user to enter a set value for this option. Enter the
desired error frequency by using the arrow keys. Press [
[ ] to move the cursor to the desired location and press
[ ]
to increase or decrease the number. Then press [ENTER] .
menu earlier in this chapter.
[ ] and
[ ] and
[ ] and
[ ] and
Programming Site Data
]
and
]
and
]
and
]
and