Table of Contents
Advertisement
6.18.3 Using the riding light
The drive system needs to be already switched
on to turn on the riding light.
1
Figure 122: Position of riding light button (1)
Press the light button for longer than
1 seconds.
The front light and rear light are both switched
on (riding light symbol is displayed) and
switched off (riding light symbol is switched off)
at the same time.
6.18.4 Setting the brightness of indicators
The ambient light sensor regulates the indicator
brightness.
The ambient light sensor must be clean and must
not be covered.
1
2
Figure 123: Position of increase brightness button (2) and
decrease brightness button (1)
Press the increase brightness button and
decrease brightness button to set the
brightness of the indicator LEDs.
About these operating instructions
6.18.5 Using the push assist system
CAUTION
!
Injury from pedals or wheels
The pedals and the drive wheel turn when the
push assist system is used. There is a risk of
injury if the ebike wheels are not in contact with
the ground when the push assist system is used
(e.g. when carrying the ebike up stairs or when
placing it on a bicycle rack).
Only use the push assist mode when pushing
the ebike.
You must steer the ebike securely with both
hands when using push assist.
Allow for enough freedom of movement for the
pedals.
The push assist helps move the ebike. The push
assist system speed depends on the selected
gear. The lower the selected gear is, the lower
the speed in the push assist function is (at full
power). The maximum speed is 3 km/h.
We recommend using first gear for cycling uphill
to protect the drive.
Figure 124: Position of push assist button (1)
1
123
Advertisement
Chapters
Table of Contents
