GE AquaTrans AT868 User Manual page 81

Table 6-1: Available Diagnostic Parameters (Continued)
Option Bar
Displays the normalization factor for the
NFup
upstream transducer.
Displays the normalization factor for the
NFdn
downstream transducer.
Displays the speed of sound in the
Cxdcr
transducer (clamp-on only).
Procedure Options
Diagnostics
Description
After completing the above steps, the meter returns to the Global I/O
window. Do one of the following:
•
To perform another programming function, see Appendix A,
Menu Maps, to navigate to the desired menu.
To leave the User Program, press [ESC] four times.
•
After leaving the User Program, the AT868 will reset itself and will
begin to display the parameters specified in this section. If more than
one parameter was set up, each of the parameters will be displayed in
sequence, with a pause of several seconds between display changes.
September 2004
Good Bad
0.85-1.0 <0.85
0.85-1.0 <0.85
N.A. N.A.
6-3