Advertisement
14 www.electrolux.com
Continuous Drainage
Once the continuous drainage is enabled,
water can be automatically emptied from
the appliance and the water will not flow
into the water tank unless there is
something wrong with the continuous
drainage. You will need a garden hose and
a drain nearby to discharge the water into
before conducting this operation.
Following the steps below to make sure
the hose to be connected correctly:
1. Pull down the drainage plug at the back
of the unit.
2. Push the garden hose firmly into the
drainage outlet to make sure the hose
to be connected to the unit properly so
there will be no leaks.
3. Direct the hose toward the drain and
place the other end of the hose into the
drain, making sure that there are no
kinks that will stop the water from
flowing smoothly.
4. Select the desired humidity setting and
fan speed on the unit for continuous
draining to start.
NOTE:
• Make sure the water tank has been
installed properly before trying to
connect the garden hose to the
drainage outlet.
• Shake or pull the hose slightly to make
sure the hose is connected properly. If
there is a leak, pull out the hose and
repeat the above-mentioned hose
connection process.
• It is recommended that a Dehumidifier
Drain Hose - (xx.x mm) be used. Make
sure there are no kinks or elevations in
the hose.
• When a hose is not attached to the unit,
please ensure drainage plug to be
closed securely to prevent leakages.
Advertisement
