Advertisement
5.15 Removing collected water
There are two ways to remove collected
water.
Use the Water Tank
When the water tank is full, the unit will
beep 15 times and the Water Tank Full
indicator "
" will flash.
Following the steps below to remove the
collected water from the water tank:
1. Grip the water tank edges of the
grooves on both sides securely, then
pull out the water tank a little.
2. Hold both sides of the water tank with
even strength, and pull it out from the
unit.
3. Grip the water tank handle and open the
water tank sealing cap in the side
corner, then empty the water tank.
4. Close the sealing cap and put back the
water tank in place.
The water tank full indicator will turn off,
and the unit will start up again when the
water tank is restored in its correct
position.
NOTE:
• When you remove the water tank, do
not touch any parts inside the unit,
otherwise the product may be
damaged.
• Be sure to push the water tank gently all
the way into the unit. Banging the water
tank against anything or failing to push it
in place may cause the unit not to
operate.
• Because the castors cannot be locked,
you need to apply a limited force so that
appliance does not move suddenly.
• Discard water from water tank. The
water in the water tank is not potable.
ENGLISH
13
Advertisement
