Page 1
Firmware update procedure Recording module: AU-VREC1, Camera module: AU-V23HS1, AU-V35C1 NOTE: Ver. 2.03: After AU-V35C1 is updated, please perform ABB with the lens cap fitted on according to the procedure stated in this update manual. This is for the sensor adjustment needed after 120p mode is newly equipped.
1. Insert an SD memory card into the SD card slot ( NOT microP2 card slot ) on the unit. 2. Format the SD card (MENU : SYSTEM SETTINGS > CARDS/MEDIA > FORMAT CARD > SD CARD) Visit Panasonic professional video support website <http://panasonic.biz/sav/pass_e> and download "vsi*****.zip" firmware package.
Page 3
Firmware update procedure for Varicam series January 2015 [Perform update] 5. Insert the SD card into the SD card slot (NOT microP2 card slot) on the unit. 6. Disconnect the cable between the viewfinder and the camera body. 7. Press INFO button to display INFO screen. Press the operation button of VERSION and press the Jog Dial.. Jog Dial button INFO button VERSION operation button...
Page 4
MENU: CAMERA SETTINGS > Enhanced > Enhanced SW > ON MENU: CAMERA SETTINGS > BLACK > ABB [EXECUTE] After about a minute, “ABB ACTIVE” is displayed on the panel. When “ABB OK” is displayed, ABB is completed. However software cannot be updated, please contact Panasonic Service Engineering. Page4/5...
Firmware update procedure for Varicam series January 2015 4. Troubleshoot 1. “UPDATE” menu item does not appear. It may happen in following cases; - When package file or copied location are NOT correct (“PRIVATE” folder was not copied to the upper directory of the SD card).