from scattering across the work tray. Adjust the width of the fence to be slightly larger
than the width of the bundle.
Step 7 – Press
Single/Bundle cutting mode button and switch to bundle cutting mode
Step 8 – For subsequent cutting procedures, refer to the instructions under manual operation and
automatic operation.
Uninstalling top clamp
Follow these steps to uninstall top clamp for cutting single material:
Step 1 – Disconnect the top clamp hoses.
Step 2 – Loosen the lock nuts and remove the top clamp.
Step 3 – Remove the stud bolts.
TERMINATING A CUTTING OPERATION
To terminate a cutting operation, press either the saw bow up button or the emergency stop
button.
The saw blade will stop running when the saw bow up button is pressed.
Both the saw blade and hydraulic pump motors will stop running when the emergency stop
button is pressed.
The machine will stop automatically when an error occurs. The error message will be shown on
the screen.
4‐30
STOP
.