Table of Contents
Advertisement
Problem solving guide
With the help of the following notes minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting Miele.
Please note that a call-out charge will be applied to service visits where the
problem could have been rectified as described in these operating instructions.
Repair work to electrical appliances should only be carried out by an
authorised Miele service technician. Repairs and other work by unqualified
persons could be dangerous. Miele cannot be held liable for unauthorised
work.
Messages in the display
Problem
Code 000
lights up after switching
on
Adjust the load
lights up after a
programme is cancelled
Technical fault F
If restart is unsuccessful,
call Miele
lights up after a
programme is cancelled
Possible cause and remedy
Access via a code has been activated.
See "Settings menu - PIN Code".
In some programmes, if the drum has been
overloaded or underloaded, the programme will be
cancelled. This can also happen if the items are
already dry.
Open and close the door to resume drying.
Use the Warm air programme (timed drying) to dry
individual items.
It may be that the laundry is unevenly distributed or
has rolled up.
Disentangle the laundry and remove a few items, if
necessary.
Start the programme again.
There is no obvious cause.
Switch the dryer off and then on again.
Start a programme.
If the programme is cancelled again and an error
message appears, there is a fault. Contact Miele.
Problem solving guide
63
Advertisement
Chapters
Table of Contents
