Table of Contents
Advertisement
DOK-SUPPL*-VSP*XX.3***-IT01-EN-P
Rexroth IndraControl VSP xx.3 Panel PC
11. Reconnect the connecting cables to the hard disk. Connection pins must not be
bent!
12. Close the device door and fasten the five marked screws, see
of the screws of the housing cover" on page
13. The new hard disk parameters are identified automatically by the system. If the
operating system does not boot automatically after switching on, the power sup‐
ply is to be interrupted for at least 10 seconds. A restart needs to be carried out
again.
14. Restore the user data as well as the operating system settings for the normal
mode after a regular boot of the PC.
14.5
Display
A fading backlight causes a progressive deterioration of the readability of the display,
so that a backlight replacement is required. For further information, please contact the
Bosch Rexroth Service (see
14.6
Inserting the Extension Cards
PCIe slots and PCI slots are available to plug extension cards.
The max. power, which is available for all extension cards, is 100 watts in
total.
NOTICE
Comply with all ESD protective measures while working with modules and components!
Avoid electrostatic discharges!
WARNING
Only install released extension cards. Installation is only to be carried out by authorized
personnel.
1. Store all required user data as well as the operating system settings of your sys‐
tem either on an external storage medium or via the network connection! For in‐
formation on data backup, please refer to chapter "Data backup with Acronis...."
in the project planning manual of the panel PC.
2. Switch off the supply voltage.
chapter 17 "Service and Support" on page
Damages to the device due to electrostatic dis‐
charges!
Risk of damage to the device or corruption of appli‐
cation software due to the use of of non-released
extension cards!
Bosch Rexroth AG
fig. 14-2 "Position
33.
Maintenance
38).
35/43
Advertisement
Table of Contents
