Pc Voltage Supply X10; Serial Interface Xcom - Bosch Rexroth IndraControl VSP 3 Series Instructions Manual

DOK-SUPPL*-VSP*XX.3***-IT01-EN-P
Rexroth IndraControl VSP xx.3 Panel PC
Labeling of the Connection type
housing
XMS PS/2 mouse
XAUDIO Audio (disabled in the
BIOS by default)
Fig.9-1: Interfaces at the panel PC
9.3

PC Voltage Supply X10

Labeling Function
+ Supply voltage 24 V
– Supply voltage 0 V
NOTICE
The DC 24 V input voltage must comply with the requirements of the "Protective sepa‐
ration"!
The following conductor cross-sections for the X10 screw terminal are permissible.
Conductor
Max. conductor cross-section
Recommended conductor cross-section
Conductor cross-section AWG/kcmil, max.
Conductor cross-section AWG/kcmil, recommended
Fig.9-2: Permitted conductor cross-sections for the screw terminal
For wiring connection terminals use copper wire only.
Tighten the screw terminals (3.5 mm pin spacing) with a mounting torque
of 2.25 lb in (0.25 Nm). Tighten the screw terminals (5.08 mm pin spacing)
with a mounting torque of 5.5 lb in (0.6 Nm).
9.4

Serial Interface XCOM

Type RS232, D-Sub male connector, 9-pin
Connector type (inte‐
grated)
Mini-DIN
PS/2 female connec‐
tor
-
Danger without protective separation!
Bosch Rexroth AG
Interfaces
Mating connector or
cable (from outside)
Mini-DIN
PS/2 connector
Cross-section
6 mm 2
2.5 mm
2
8
13
19/43