Printing Alarm Settings; Stop Printing An Alarm Graph; Stop Printing To A Laser Printer; Stop Printing To A Local Digital Writer - GE ApexPro Operator's Manual

Printing alarm settings

Stop printing an alarm graph

Stop printing to a laser printer

Stop printing to a local digital writer

2001989-200E
A telemetry patient's Alarm Control tab sheet can be printed, showing all current
alarm settings and limits. Click on the Print button in the main menu to start a
printout of the Alarm Control tab sheet.
The Alarm Control tab sheet prints at the Print Window location. For more
information about setting the Print Window location, refer to
manual.
NOTE
The Alarm Control tab sheet must be the front tab of the single patient viewer in
order to print it. Click on the Alarm Control tab to bring it to the front if
necessary.
You can stop the printing of an alarm graph from any in-unit CIC Pro center
displaying the alarming patient bed.
Complete the following procedure to stop printing all print jobs sent to the laser
printer:
1. From the multi-patient viewer, click CIC Setup > CIC Defaults. The CIC
Defaults window displays.
2. Under Printer/Writer, click Cancel Print Jobs for the printer you want to stop
printing to.
3. After making your selection, complete one of the following tasks from the CIC
Defaults window:
Click OK to apply your changes and close the CIC Defaults window.
Click Cancel to cancel your changes and close the CIC Defaults window.
Click Apply to apply your changes without closing the CIC Defaults
window.
Complete the following procedure to stop printing the current print job sent to a local
digital writer:
1. Locate the digital writer.
2. Press the (Graph Stop) button located on the front of the digital writer to
stop the print job.
ApexPro™
Alarms
Chapter 9 in this
5-17