Transmitter Setup; Views - GE ApexPro Operator's Manual

Equipment setup

Transmitter setup

Views

3-2
The transmitters have the following buttons and LEDs:
ApexPro Transmitter and ApexPro CH Transmitter
ApexPro ApexPro CH
RL RA LA LL Va Vb RL RA LA LL Va Vb
N R L F Ca Cb
Change Battery
Verify Leads
Pause Alarm
ApexPro™
Function
When first powered up, the lead LEDs flash
rapidly, followed by two slow flashes. The
transmitter begins functioning after the two
slow flashes.
When any of the transmitter's buttons are
pushed, the lead LEDs flash twice.
When the battery power is running low, the
change battery LED flashes.
When pressed, the lead LEDs flash twice. If a
lead is valid, its LED stays lit for one minute.
When the Pause Alarm condition occurs, the
pause alarm LED flashes until the condition
ends. See Pausing alarms at the transmitter
on page 5-5.
605A, 205A
2001989-200E