GE
D
5535208-100, R
IRECTION
8-12-2
Assembling or replacing the Roll Stand (cont'd)
5.) Loosen the knob slightly, guide the arm into the channel and move it to the mounting position.
NOTE:
Make sure the Transformer Support Platform (larger view) in Figure 8-74 "Loosening Knob" on
page 8-303 is installed in the UP position.
NOTE:
The channel fits between the front and rear slide plates.
. 2
EV
Figure 8-74 Loosening Knob
Figure 8-75 Channel Location
Chapter 8 Replacement procedures
LOGIQ E9 S
M
ERVICE
ANUAL
8 - 303