Electrolux GT1 Push Operator's Manual page 8

U
- nscrew the security knob in the direction of
the arrow (threading on left), then pull out the
mixing unit, the bell shaped seal and the bowl
gasket on the back (fig.9).
R
- emove the drip tray by rotating it upward
and pulling it outward (fig.10).
T
- horoughly wash all the removed components
with hot water and dishwashing, but do not use
abrasive detergents or powders that can
damage the bowl.
IMPORTANT
D
o not use too aggressive sanitizers or
detergents, these kind of products could
damage the bowl and the other
components.
CAUTION
N
ever perform these washing operation
with a dish washing machine; failure to do
so could seriously damage the unit's parts.
R
- inse well and then place all the components
in the sanitizer solution; for proper sanitizing
the parts must remain fully plunged for 15
minutes or as recommended by the sanitizer
manufacturer.
A
- fter respecting the correct sanitizing period,
rinse well all the components with clean water
and dry them up with a clean cloth.
T
- horoughly wash the evaporator and the drip
tray surfaces with a sponge soaked with the
sanitizer (see fig.11).
R
- epeat all these operations with a clean
sponge soaked with water and carefully dry up
all the surfaces with a clean cloth.
Data di emissione: Febbraio, 2019 Revisione: 6
Fig. 9
Fig. 10
Fig. 11
Pag. : 8/28