LG Styler S3RERB Service Engineering Manual page 2

This service engineering manual is used for product repair. Repair work, even if it is minor,
may cause injury or fire. Manufacturer or seller of this product is not responsible for the prob-
lem that occurs due to misassembly of the product.
Be sure to pull out the power cord before you service the product. If you need power sup-
ply for diagnosis or test, pull out the power cord immediately after performing the neces-
sary check.
Be sure to wear safety gloves and goggles when you repair the product in order to prevent
injury or accident.
Reconnecting the Ground Wire
Be sure to reconnect the ground wire if you disconnected it for product repair.
1. First, check if the short circuit has occurred in the main body.
2. When you are handling the electric parts, be sure to pull out the power cord before you
work on it.
3. If you need to test the product while power is being applied, be sure to wear rubber
gloves to prevent electric shock.
4. When you use gauges, be sure to check the rated current, voltage, and capacity.
5. Make sure that water does not get into electric parts around the machine room.
6. When you tilt the product to front or rear, remove the objects on top of the product to
prevent them from falling. Especially, be careful of thin objects (e.g. glass panel).
7. When the heat pump cycle is damaged, you should contact the LG repair shop.
(This is to prevent the refrigerant gas inside the cycle from contaminating the house.)
8. Be extra careful when you perform repair that may cause safety accidents to ensure the
safety of the customers.
Safety Precautions
!
Caution
Safety Precautions
2