Before You Start - Nokia Check Point IP150 Installation Manual

Note
Back up your files to a remote system on a regular basis. For back up and restore
procedures, see the Getting Started Guide and Release Notes for the version of Check
Point IPSO you are using.

Before You Start

To replace the hard-disk drive in your appliance, you need the following:
Physical access to the appliance
A Check Point-approved hard-disk drive
Access to the appliance through Network Voyager
A Phillips-head screwdriver
To replace a hard-disk drive
1. Use Check Point Network Voyager or the CLI to perform an orderly shutdown of the IP150.
For information about how to access Network Voyager and the related reference materials,
see
Press the power switch, located on the back of the appliance, to turn off power to the
appliance.
2. Remove the power cord from the IP150 appliance, and remove the appliance from the rack.
3. Place the appliance right-side up and place it on a safe and protected work surface.
4. Remove the three top-cover screws and slide the cover back to remove it from the appliance.
Check Point IP150 Security Platform Installation Guide
"Using Check Point Network Voyager"
Replacing a Hard-Disk Drive
on page 29.
00667
39