Connect the Panasonic HOME IoT App to the Home IoT Gateway
STEP1
8
First, make the initial connection
from the smartphone to the Gateway.
9
Switch the connection mode to "ON".
Prepare the Gateway and
check that the power is on.
Tap the
"Next" button.
Check that the Status LED on the rear of the Gateway is either lit or
double or triple flashing, and set WLAN AP switch 1 to the On posi-
tion.The Gateway will immediately enter AP mode. Once in AP mode,
the Application LED on the front of the Gateway will flash in orange.
Application LED
If there are no
problems, tap
the "Next"
button.
11
Status LED
WLAN AP switch
The Gateway may take around 1 minute
Note
to boot after powering on.
Installer Tasks
Rear