Panasonic DVC PRO Studio AJ-D950P Service Manual page 856

3-7-27. L-M Brake Release U. Replacement
(Installation of L-M Brake Release Unit)
1. Remove the top panel.
2. Remove the front loading unit.
3. Remove the screw (A) and remove the L-M Brake
Release Unit.
(Installation of L-M Brake Release Unit)
1. Install a new L-M Brake Release Unit as reverse
order of its removal.
L-M Brake Release Unit Removal
3-7-28. Slide Rod Unit Replacement and
Adjustment
(Removal of Slide Rod Unit)
1. Remove the top panel.
2. Remove the front loading unit.
3. Remove the L-M Brake Release Unit. (Refer to L-
M Brake Release Unit Replacement.)
4. Remove the Reel Drive Sensor board. (Refer to
Reel Drive Motor Unit Replacement.)
5. Remove the cut washer (A) and remove the Reel
Drive Cam Gear.
6. Remove the cut washer (B) and remove the MIC
Drive Arm Unit.
7. Remove the cut washer © and remove the MIC
intermittent gear.
8. Remove the cut washer (D) and remove the Reel
Drive Arm Unit.
9. Remove the supply and take-up reel rotor unit.
(Refer to Supply and Take-up Reel Table Unit
Replacement.)
10. Remove the cut washer (E) and remove the supply
and take-up side base drive arm unit.
11. Remove the cut washer (F) and remove the slide
load.
Slide Rod Unit Removal
Washer (A)
Washer (C)
Cam Gear
Reel Drive Arm Unit Removal
(Installation of Slide Rod Unit)
1. Install a new Slide Rod Unit as reverse order of its
removal.
2. When Reel Drive Cam Gear and MIC Intermittent
Gear are installed phase adjustment is necessary.
Washer (B)
MIC Drive Arm
MIC Gear