Toro 137-5470 Installation Instructions

Battery Cable Kit
Groundsmaster
Model No. 137-5470
Installation
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical
or chemicals known to the State of
California to cause cancer, birth defects,
or reproductive harm.
Preparing the Machine
1. Park the machine on a level surface.
2. Lower all decks to the ground.
3. Engage the parking brake.
4. Shut off the engine and remove the key.
5. Allow the machine to cool.
Accessing the Battery
Compartment
Note:
Retain all parts removed unless otherwise
directed.
1. Disconnect the battery using the
battery-disconnect switch; refer to your
Operator's Manual.
2. Remove 3 flange screws from each side of the
rear bumper as shown in
Important:
Support the bumper so that it
will not fall before removing any fasteners.
3. Loosen the remaining flange screws securing
the rear bumper to the frame and pivot the
bumper downward.
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® 5900 or 5910 Rotary Mower
(Figure 1).
Register at www.Toro.com.
Figure 1
1. Rear bumper
2. Flange screws (remove
from both sides)
4. Loosen the knobs and remove both side panels
(Figure 2).
Figure 2
1. Knobs
5. Loosen the 4 flange screws on the bottom of the
rear shroud and remove the 2 flange screws on
each side (Figure
Original Instructions (EN) All Rights Reserved *3416-805* A
Printed in the USA
Form No. 3416-805 Rev A
Installation Instructions
3. Flange screw (loosen on
both sides)
2. Side panel
3).
g199824
g199825