Serial Interface Xcom; Settings Of The Serial Interface; Fig. 7-3: Pin Assignment Com - Bosch Rexroth VSB 40.1 Project Planning Manual

7-2
PC Box

Serial Interface XCOM

Serial interface

Settings of the Serial Interface

Control Panel
XCOM: A serial standard interface is provided at connection XCOM.
D-Sub male connector, 9-pin
Type:
Cable length:
Cable type:
Transmission rate:
Handshake:
Interrupt (IRQ):
I/O address:
BIOS presettings:
1
6
Fig. 7-3: Pin assignment COM
Note: If the uninterruptible power supply UPS is used, this interface
is required for the communication with the UPS. The UPS is
available as accessories.
To find out settings of the transfer parameters for the serial interfaces,
please refer to the description of the installed operating system (for
Windows under Settings/Control Panel, ...").
BIOS The standard BIOS setting of COM (Serial Port A) is AUTO (automatic
parameter assignment). If a direct parameter assignment is required, you
should choose the following settings:
• COM = 3F8H
Note: Interrupt (IRQ) and I/O address must coincide with the settings
made in BIOS.
RS232
Max. 15 m
Shielded, cross section min. 0.14 mm²
Max. 115200 bits/s
Hardware and software handshake (XON, XOFF)
4
AUTO (or 3F8H)
Enabled
XCOM
5
9
Shield applied to the metal housing
of the plug-in connector
DOK-SUPPL*-VSB*40.1***-PR01-EN-P
VSB 40.1
1
2
3
4
5
6
7
8
9
Com_sst.FH9