Leds During Device Start-Up - Panasonic ISE SMART CONNECT KNX Product Manual

Colour
(red, continuously on) Programming mode is active.
(off)
Table 5: Device status – programming mode
The status indicators for the network are on the underside of the device.
Figure 16: Network LEDs
No. Element
1 "Connection speed" LED
2 "Communication" LED
3 IP connection
Table 6: Status of the device network

8.1.1 LEDs during device start-up

The "APP" and "COM" LEDs have different meanings depending on the phase in the operating mode.
After the power supply is switched on or after power returns, the device indicates its status using the
following LED combinations:
ISE SMART CONNECT KNX Panasonic
© 2019 ise Individuelle Software und Elektronik GmbH
►
See Assigning a physical address, p. 32.
Programming mode is deactivated.
• LED lights up green: 100 Mbit/s
• LED is off: 10 Mbit/s (There is no connection if LED 2
also off. Check whether the cable is correctly con-
nected.)
• LED lights up yellow-orange: Connected but currently no
telegram traffic
• LED flashes yellow-orange: Telegram traffic
2x RJ45 (integrated switch)
Commissioning and configuration
Description
Description
1-000C-000
S. 25 / 69